Bong Hero

Please read the PDF file in the zip file before doing anything!!!(printing or building) be careful when using and building!!! AAAAnd if you are using it, try to inhale only since exhaling is really hard to do consistently.

This is a shell for a game controller for the guitar hero game, shaped like a bong.

the shell is Intended for the PS2 or PS3 that I showed in the video.

The video link: https://www.youtube.com/watch?v=u6sCdcjZBxo

Parts needed:

• Guitar hero controller (DUH!)
• Electric tape
• Super glue
• M3x10 12 mm height screws ( just buy a variety pack)
• M3x10 6 mm height screws ( just buy a variety pack)
• 80 grit sandpaper (or 100 grit)
• Some wires
• 20xM3 inserts in different sizes [3-6 mm height] ( just buy a variety pack)
• Balloons
• 78 mm paper clips
• Rubber bands
• Tin
• One or 2 50v 0.47 microfarad capacitors
• Shrinking tubes
• Aluminium foil
• Duct tape or masking tape

Recommended print settings:

• 20% infill
• use supports for anything that has overhangs or is dome-shaped. (about half of them need supports)
• I used esun PLA use PETG if you want it to be more sturdy and durable.

If you want to change, add, customize, or just in general improve my design you are more than welcome. just give me some recognition in the process

Do you want to support me? really???? check my socials and my youtube channel: https://www.youtube.com/@Nightmare-Engineer https://twitter.com/NightmareEnginr https://www.facebook.com/NightmareEngineer0/ https://www.instagram.com/nightmareengineer/